Back to 57MM-WB02 Product Page
Knowledge Base
Adding Another CPE (Camera) unit to an Existing Wireless Bridge for PTMP
-unit-to-an-existing-wireless-bridge-for-ptmp-step-1.png)
1. Connect to the units Wi-Fi signal. The Wi-Fi signal can be identified using the last 4 digits of the units MAC address which also form the last 4 digits of the SSID. Please wait for the Wi-Fi symbol to appear at the top of the device, confirming the connection, before entering the IP address. Connect to IP address 192.168.120.1. If a password is required use ‘admin’.
-unit-to-an-existing-wireless-bridge-for-ptmp-step-2.png)
2. Close the ‘Configuration is uninitialized’ panel
-unit-to-an-existing-wireless-bridge-for-ptmp-step-3.png)
3. Select ‘Wireless’
-unit-to-an-existing-wireless-bridge-for-ptmp-step-4.png)
4. Select ‘WDS’
-unit-to-an-existing-wireless-bridge-for-ptmp-step-5.png)
5. Scan for the WDS signal from the host wireless bridge.
-unit-to-an-existing-wireless-bridge-for-ptmp-step-6.png)
6. Select the host’s WDS
-unit-to-an-existing-wireless-bridge-for-ptmp-step-7.png)
7. You may be required to reset the system password
-unit-to-an-existing-wireless-bridge-for-ptmp-step-8.png)
8. Select ‘OK’ if OK.
-unit-to-an-existing-wireless-bridge-for-ptmp-step-9.png)
9. Operation succeeded’ should appear
-unit-to-an-existing-wireless-bridge-for-ptmp-step-10.png)
10. Monitor the extra CPE units’ alignment lights for a successful connection
-unit-to-an-existing-wireless-bridge-for-ptmp-step-11.png)
1. Refresh the IP address to see the new CPE unit attached (30secs-2mins)